#==============================================================================
##
##      sim.S
##
##      Simulator hardware setup
##
##=============================================================================
#####COPYRIGHTBEGIN####
#                                                                          
# -------------------------------------------                              
# The contents of this file are subject to the Red Hat eCos Public License 
# Version 1.1 (the "License"); you may not use this file except in         
# compliance with the License.  You may obtain a copy of the License at    
# http://www.redhat.com/                                                   
#                                                                          
# Software distributed under the License is distributed on an "AS IS"      
# basis, WITHOUT WARRANTY OF ANY KIND, either express or implied.  See the 
# License for the specific language governing rights and limitations under 
# the License.                                                             
#                                                                          
# The Original Code is eCos - Embedded Configurable Operating System,      
# released September 30, 1998.                                             
#                                                                          
# The Initial Developer of the Original Code is Red Hat.                   
# Portions created by Red Hat are                                          
# Copyright (C) 1998, 1999, 2000 Red Hat, Inc.                             
# All Rights Reserved.                                                     
# -------------------------------------------                              
#                                                                          
#####COPYRIGHTEND####
##=============================================================================
#######DESCRIPTIONBEGIN####
##
## Author(s):   nickg
## Contributors:        nickg
## Date:        1997-11-11
## Purpose:     Simulator hardware setup
## Description: This file contains any code needed to initialize the
##              hardware on the PowerPC simulator.
##
######DESCRIPTIONEND####
##
##=============================================================================

#include <pkgconf/hal.h>
        
#include <cyg/hal/arch.inc>

#------------------------------------------------------------------------------
                
        .globl  hal_hardware_init
hal_hardware_init:

#if 0   
        # Set up the BAT registers to cover same address spaces

        # ibat0
        # base addr 0xfff00000
        # length 1M
        # WIMG = 0000
        # covers ROM
        lwi     r4,0xfff0001f
        mtibatu 0,r4
        lwi     r4,0xfff00002
        mtibatl 0,r4
        
        # ibat1
        # base addr 0x00000000
        # length 256M
        # WIMG = 0000
        # covers DRAM and slots
        lwi     r4,0x00001fff
        mtibatu 1,r4
        lwi     r4,0x00000002
        mtibatl 1,r4
                
        # dbat0
        # base addr 0xfff00000
        # length 256M
        # WIMG = 0101
        # covers ROM for data access
        lwi     r4,0xfff01fff
        mtdbatu 0,r4
        lwi     r4,0xfff0002a
        mtdbatl 0,r4

        # dbat1
        # base addr 0x00000000
        # length 256M
        # WIMG = 0000
        # covers DRAM and slots
        lwi     r4,0x00001fff
        mtdbatu 1,r4
        lwi     r4,0x00000002
        mtdbatl 1,r4
                
        # Enable translation in the MSR
        mfmsr   r3
        lwi     r4,0x00000030
        or      r3,r3,r4
        mtmsr   r3
#endif          
        blr

#------------------------------------------------------------------------------
# end of sim.S