new file mode 100644
--- /dev/null
+++ b/packages/io/serial/current/src/arm/cma230_serial.h
@@ -0,0 +1,151 @@
+#ifndef CYGONCE_ARM_CMA230_SERIAL_H
+#define CYGONCE_ARM_CMA230_SERIAL_H
+
+// ====================================================================
+//
+//      cma230_serial.h
+//
+//      Device I/O - Description of Cogent CMA230 serial hardware
+//
+// ====================================================================
+//####COPYRIGHTBEGIN####
+//
+// -------------------------------------------
+// The contents of this file are subject to the Cygnus eCos Public License
+// Version 1.0 (the "License"); you may not use this file except in
+// compliance with the License.  You may obtain a copy of the License at
+// http://sourceware.cygnus.com/ecos
+// 
+// Software distributed under the License is distributed on an "AS IS"
+// basis, WITHOUT WARRANTY OF ANY KIND, either express or implied.  See the
+// License for the specific language governing rights and limitations under
+// the License.
+// 
+// The Original Code is eCos - Embedded Cygnus Operating System, released
+// September 30, 1998.
+// 
+// The Initial Developer of the Original Code is Cygnus.  Portions created
+// by Cygnus are Copyright (C) 1998,1999 Cygnus Solutions.  All Rights Reserved.
+// -------------------------------------------
+//
+//####COPYRIGHTEND####
+// ====================================================================
+//#####DESCRIPTIONBEGIN####
+//
+// Author(s):           gthomas
+// Contributors:        gthomas
+// Date:        1999-05-20
+// Purpose:     Internal interfaces for serial I/O drivers
+// Description:
+//
+//####DESCRIPTIONEND####
+//
+// ====================================================================
+
+// Description of serial ports on Cogent CMA230
+
+struct serial_port {
+    unsigned char _byte[32];
+};
+
+#define reg(n) _byte[n*8]
+
+// Receive control registers
+#define rhr reg(0)    // Receive holding register
+#define isr reg(2)    // Interrupt status register
+#define lsr reg(5)    // Line status register
+#define msr reg(6)    // Modem status register
+#define scr reg(7)    // Scratch register
+
+// Transmit control registers
+#define thr reg(0)    // Transmit holding register
+#define ier reg(1)    // Interrupt enable register
+#define fcr reg(2)    // FIFO control register
+#define lcr reg(3)    // Line control register
+#define mcr reg(4)    // Modem control register
+#define ldl reg(0)    // LSB of baud rate
+#define mdl reg(1)    // MSB of baud rate
+
+// Interrupt Enable Register
+#define IER_RCV 0x01
+#define IER_XMT 0x02
+#define IER_LS  0x04
+#define IER_MS  0x08
+
+// Line Control Register
+#define LCR_WL5 0x00    // Word length
+#define LCR_WL6 0x01
+#define LCR_WL7 0x02
+#define LCR_WL8 0x03
+#define LCR_SB1 0x00    // Number of stop bits
+#define LCR_SB1_5 0x04  // 1.5 -> only valid with 5 bit words
+#define LCR_SB2 0x04
+#define LCR_PN  0x00    // Parity mode - none
+#define LCR_PE  0x0C    // Parity mode - even
+#define LCR_PO  0x08    // Parity mode - odd
+#define LCR_PM  0x28    // Forced "mark" parity
+#define LCR_PS  0x38    // Forced "space" parity
+#define LCR_DL  0x80    // Enable baud rate latch
+
+// Line Status Register
+#define LSR_RSR 0x01
+#define LSR_THE 0x20
+
+// Modem Control Register
+#define MCR_DTR 0x01
+#define MCR_RTS 0x02
+#define MCR_INT 0x08   // Enable interrupts
+
+// Interrupt status register
+#define ISR_Tx  0x02
+#define ISR_Rx  0x04
+
+static unsigned char select_word_length[] = {
+    LCR_WL5,    // 5 bits / word (char)
+    LCR_WL6,
+    LCR_WL7,
+    LCR_WL8
+};
+
+static unsigned char select_stop_bits[] = {
+    0,
+    LCR_SB1,    // 1 stop bit
+    LCR_SB1_5,  // 1.5 stop bit
+    LCR_SB2     // 2 stop bits
+};
+
+static unsigned char select_parity[] = {
+    LCR_PN,     // No parity
+    LCR_PE,     // Even parity
+    LCR_PO,     // Odd parity
+    LCR_PM,     // Mark parity
+    LCR_PS,     // Space parity
+};
+
+// The Cogent board has a 3.6864 MHz crystal
+static unsigned short select_baud[] = {
+    0,    // Unused
+    4608, // 50
+    0,    // 75
+    2094, // 110
+    0,    // 134.5
+    1536, // 150
+    0,    // 200
+    768,  // 300
+    384,  // 600
+    182,  // 1200
+    0,    // 1800
+    96,   // 2400
+    0,    // 3600
+    48,   // 4800
+    32,   // 7200
+    24,   // 9600
+    16,   // 14400
+    12,   // 19200
+    6,    // 38400
+    4,    // 57600
+    2,    // 115200
+    0,    // 230400
+};
+
+#endif // CYGONCE_ARM_CMA230_SERIAL_H